Intelligent equipment
Yejing specializes in the design and manufacture of aluminum profile extrusion equipment.
New short-stroke extruder
5500T short-stroke extrusion press
1. Higher Productivity: Shorter non-extrusion time.
2. Servo Feeding: Faster, more precise log loading.
3. Efficient Heating: Faster container heating with plug-in tubes.
4. Square Cutter: Higher precision; easier maintenance.
5. Pre-stressed Frame: Minimized elastic deformation.
6. Enhanced Stability: Optimized frame for better precision.
7. Eco-efficient: Less hydraulic oil; lower costs.
①
Structure of a rear-bar short-stroke extruderBack loading short stroke press structure

Figure 1. Schematic diagram of a short-stroke extruder with a rear bar.
1. Front crossbeam 2. Mold 3. Ingot holder 4. Aluminum rod 5. Extrusion pad
6. Extrusion rod 7. Moving crossbeam 8. Main plunger 9. Rear crossbeam 10. Main hydraulic cylinderAs shown in Figure 1, the operating sequence of the rear-mounted bar short-stroke aluminum extrusion press is as follows: the extrusion rod first moves away from the extrusion centerline, reserving a position for the rod feeding mechanism. The rod feeding mechanism then delivers the aluminum rod to the extrusion centerline and pushes it into the billet cylinder. After the rod feeding mechanism leaves, the extrusion rod returns to the extrusion centerline. The main plunger drives the extrusion rod forward, and extrusion begins.
The rear-mounted bar short-stroke extrusion press has lower requirements for aluminum rods and can accommodate aluminum rods sheared by hot shearing machines as well as two-section short rod bar stackers. This structure is suitable for small to medium tonnage models.②
Structural form of front bar short stroke extruderBack loading short stroke press structure

Figure 2. Schematic diagram of the front bar short-stroke extruder.
1. Front crossbeam 2. Mold 3. Aluminum rod 4. Ingot holder 5. Extrusion pad
6. Extrusion rod 7. Moving crossbeam 8. Main plunger 9. Rear crossbeam 10. Main hydraulic cylinderAs shown in Figure 2, the operating sequence of the front-upper-bar short-stroke extrusion press is as follows: the main plunger and ingot holder retract until a space for feeding the aluminum rod is reserved between the ingot holder and the die; the rod feeding mechanism feeds the aluminum rod to the extrusion centerline; the ingot holder advances and catches the aluminum rod; finally, the main plunger drives the extrusion rod forward to begin extrusion.
The front-upper-bar short-stroke extrusion press has high requirements for the rod feed and can only use sawn aluminum rods. This structure is suitable for large-tonnage models.
